This model is for general purpose diametral strain measurement with furnace and induction heating systems. Quartz rods and water-cooling allow the unit to be used for high temperature testing of metals, ceramics and composites. With induction heating, this model often can be used without water-cooling.

When used in furnaces, the extensometer is often mounted directly to the furnace side cut-out. Optional load frame mounting brackets are available for supporting the extensometer in cases where furnace mounting is not possible. These optional mounts are used with induction heating or furnaces systems.

The Model 3580 extensometers are strain gaged devices, making them compatible with any electronics designed for strain gaged transducers. Most often they are connected to a test machine controller. The signal conditioning electronics for the extensometer is typically included with the test machine controller or may often be added. In this case the extensometer is shipped with the proper connector and wiring to plug directly into the electronics. For systems lacking the required electronics, Epsilon can provide a variety of solutions, allowing the extensometer output to be connected to data acquisition boards, chart recorders or other equipment.

A PDF document containing specifications on the 3580 can be downloaded from the following link: PDF DOWNLOAD.

For price, delivery or other information, please click here to submit our information request form.

• May be left on through specimen failure.
• Full bridge, 350 ohm strain gaged design for compatibility with nearly any test system.
• All standard units meet existing ASTM class B-1 and ISO 9513, class 0,5 requirements for accuracy.
• Each unit comes with a spare set of quartz rods, universal water-cooled mounting bracket and a foam lined storage case.
• Rugged, dual flexure design for strength and improved performance. Much stronger than single flexure designs, this also allows cyclic testing at higher frequencies.
• Versions available for use in vacuum environments (consult factory).

Excitation: 5 to 10 VDC recommended, 12 VDC or VAC max.

Output: 2 to 4 mV/V nominal, depending on model

Linearity: ≤0.15% of full scale measuring range, depending on model

Temperature Range: Standard is -40 °C to +1000 °C (-40 °F to 1832 °F)

Cable: Integral, ultra-flexible cable, 8 ft (2.5 m) standard

Specimen Size: Works with samples 0.18 to 0.63 inch diameters (4.5 to 16 mm)

Contact Force: Adjustable, 100 to 300 g typical